I am looking for an Electronic Engineer to teach me PCB design using EasyEDA, select appropriate components (pull-up resistors, capacitors, etc.), and handle PCB manufacturing at JLCPCB (including basic and extended component choices).

We must share screens to do an end-to-end example prototype board — from basic sketch to manufacture.

I have a project for a Home Automation Controller (already in Prototype v3) — see picture.
I need to refine it, especially to make it easier to deploy in the field (choosing the right connectors, for example, DIN rail mounting).

This project uses:
- ESP32 Dev Board
- OLED Display
- PCF8575 I2C mux
- RF 433 rx and tx
- Relay Bank Modules
- ULN2803

Skills required:
- Proficiency in EasyEDA
- Strong knowledge of circuit design and PCB layout
- Good communication and teaching skills
- Preferred languages are: Portuguese, English, Spanish (in this order)

It is part of the job to advise me about additional needed components, such as resistors, capacitors, power supply, etc. (I am a computer programmer — not an electronics engineer).

Experience developing similar products is a PLUS. Please tell me your background and what you have done before using these components.